High-efficiency coating machine cleaning work

The high-efficiency coating machine is a very good equipment. I don't think I have to say this. Since the advent of the high-efficiency coating machine, it has been well received by users. For this reason, I have introduced the high-efficiency coating machine to everyone. Today, I will talk to you about the cleaning work.

1. After use, rinse with clean water to prevent clogging. If the clogging occurs, please disassemble the nozzle according to the instructions of the spray gun and remove the muzzle residue with a fine needle.

2. If the coating pan is not used for a long time, it should be cleaned and oiled on the surface.

3. The lubricating oil in the gearbox and the grease in the rolling bearing inner cavity should be replaced regularly (generally no more than six months)

4. In order to ensure that the worm gear in the gearbox meets the lubrication conditions of the transmission, the temperature rise of the cabinet during operation shall not exceed 50 °C.

5. The oil-proof seal on the shaft end of the worm should be checked and replaced regularly (not more than six months).

6. Do not remove the high-efficiency coating machine at will when cleaning.

When cleaning the high-efficiency coating machine, the power must be cut off, the dust and waste outside the equipment must be removed, the sewage pipe should be connected, and the equipment should be cleaned. Cleaning of the mixing tank, peristaltic pump, spray gun and silicone tube. First drain the insulation water in the mixing tank, rinse the insulation tank with drinking water, and drain the water. Insulate the inner bucket first by adding a certain amount of drinking water, add the cleaning agent, brush the inner wall with a soft brush with a handle, remove the sewage, and rinse it with drinking water. Then add a certain amount of drinking water and cleaning agent, start stirring, connect the peristaltic pump and spray gun to the discharge port, start the peristaltic pump, open the spray gun, spray the silicone tube, peristaltic pump, spray gun and spray line, then change into drinking water. Repeated spray washing, cleaning, and then replaced with purified water, after washing, disinfection of the entire spray device with 75% ethanol. The host is clean. Close the drain pipe, connect the drinking water inlet pipe, open the valve, and add water to the coating roll.

The cleaning of the high-efficiency coating machine is a good maintenance work for the high-efficiency coating machine, which can be more beneficial to increase work efficiency and extend its life.