Aluminum foil film thickness measuring instrument operation steps

The aluminum foil film is a composite film of aluminum foil and plastic film. The thickness of the aluminum foil is different and the application is different. This requires measuring the thickness of the aluminum foil film with an aluminum foil film thickness measuring instrument.

Aluminum foil film thickness measuring instrument

Sanquan Zhongshi Aluminum Foil Film Thickness Measuring Instrument CHY-U is not only used for accurate measurement of thickness of film, battery separator, solar cell wafer, paper, tape, etc., but also can measure aluminum foil film thickness, which is an ultra-high test precision. Fully automatic thickness gauge, thickness gauge is widely used in quality inspection institutions, film manufacturers, photovoltaic plants and other units.

Aluminum foil film thickness measuring instrument operation steps 1 According to the sample type, select the presser foot according to Table 1. For samples with uneven surface structure, the diameter of the presser foot should be less than the length of the pattern cycle. If necessary, the thickness of the concave and convex part can be measured and reported by the smaller presser foot.
2 Clean the presser foot and reference plate to check the movement flexibility of the presser foot. Set the pressure according to Table 1, then drive the presser foot onto the reference plate and set the thickness gauge to zero.
3 Lift the presser foot and place the specimen on the reference plate without tension or deformation.
4 Place the presser foot on the sample and keep a constant pressure, and read the thickness indication value after the specified time.
5 Repeat 3 to 4 procedures until the specified number of parts or each sample is measured.
6 If you need to measure the thickness under different pressures (such as geotextiles), you can repeat 2~5 procedures for each pressure. You can also repeat 2~4 procedures for each measurement site or each sample from low pressure. , measure the thickness of each pressure at the same point, then replace the test site or sample, repeat the operation of the previous carbon until the specified number of parts or each sample is measured.

MK-M4FJ9

4 Wire Video Intercom System,Analog 4 Wire Intercom System,4 Wire Video Doorbells,Doorbell System For Villa,4 Wire Intercom Door Phone

Zhuhai Mingke Electronics Technology Co., Ltd , https://www.zhmkdz-electronics.com

Posted on